Характеристики и описание
Описание оборудования | |
|---|---|
| EtherNet/IP + MODBUS/TCP com unit with data decoupling, double master for 2 AS-Interface networks | |
General specifications | |
| AS-Interface specification | V3.0 |
| PLC-Functionality | activateable |
| Duplicate address detection | from AS-Interface slaves |
| Earth fault detection | integrated |
| EMC monitoring | integrated |
| Diagnostics function | Extended function via display |
| UL File Number | E223772 only from low voltage, limited energy source (SELV or PELV) or listed Class 2 source |
Indicators/operating means | |
| Display | Illuminated graphical LC display for addressing and error messages |
| LED AS-i ACTIVE | AS-Interface operation normal; LED green |
| LED CONFIG ERR | configuration error; LED red |
| LED PRG ENABLE | autom. programming; LED green |
| LED POWER | voltage ON; LED green |
| LED PRJ MODE | projecting mode active; LED yellow |
| LED SER ACTIVE | ethernet active; LED green |
| LED U AS-i | AS-Interface voltage; LED green |
| Button | 4 |
| Switch SET | Selection and setting of a slave address |
| OK button | Mode selection traditional-graphical/confirmation |
| Button MODE | Mode selection PRJ-operation/save configuration/cursor |
| ESC button | Mode selection traditional-graphical/cancel |
Electrical specifications | |
| Insulation voltage | ? 500 V |
| Rated operating voltage | from AS-Interface 30 V DC |
| Rated operating current | ? 250 mA PELV |
Interface 1 | |
| Interface type | 2 x RJ-45 |
| Protocol | EtherNet/IP + MODBUS TCP/IP acc. to IEEE 802.3 supports device level ring protocol DLR |
| Transfer rate | 10 MBit/s / 100 MBit/s , Automatic baud rate detection |
Interface 2 | |
| Interface type | RS 232, serial Diagnostic Interface |
| Transfer rate | 19,2 kBit/s |
Interface 3 | |
| Interface type | Chip card slot |
Connection | |
| Ethernet | RJ-45 |
| AS-Interface | spring terminals, removable |
Directive conformity | |
| Electromagnetic compatibility | |
Standard conformity | |
| Electromagnetic compatibility | EN61000-6-2:2005, EN61000-6-4:2007 |
| Degree of protection | EN60529:2000 |
| AS-Interface | EN62026-2:2013 |
Approvals and certificates | |
| UL approval | An isolated source with a secondary open circuit voltage of ? 30VDC with a 3A maximum over current protection. Over current protection is not required when a Class 2 source is employed. UL mark does not provide UL certification for any functional safety rating or aspects of the device. |
Ambient conditions | |
| Ambient temperature | 0 ... 55 °C (32 ... 131 °F) |
| Storage temperature | -25 ... 85 °C (-13 ... 185 °F) |
<img class="noprint nodialog" src="https:/</strong> | |
Описание оборудования
AS-Interface gateway VBG-ENX-K20-DMD-EV
Под заказ
Цену уточняйте
Минск ∙
Доставка
Оплата и гарантии